The following is an overview of the user manual for the Z-Wave product Plug-in Switch (Dual Plug Simultaneous Control) (39342 / ZW4106)from Honeywell. To view other Z-Wave products and manuals from Honeywell follow that link.
Overview
Security
As a Z-Wave Plus certified product, Plug-in Switch (Dual Plug Simultaneous Control) supports Z-Wave S2 security. The following security modes are directly supported:
Features
Honeywell describes Plug-in Switch (Dual Plug Simultaneous Control) as having the following features:
- Color
- Firmware updatable via a compatible Z-Wave gateway
- Switch Load Capacity Current
- Switch Load Capacity Watts
- Loads Controlled
- Switch Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Adding your device to a Z-Wave network:
1. Follow the instructions for your Z-Wave certified controller to
include the device to the Z-Wave network.
2. Once the controller is ready to include your smart switch,
single press and release the manual/program button on the
smart switch to include it in the network.
Now you have complete control to turn your lamp ON/OFF
according to groups, scenes, schedules and interactive
automations programmed by your controller.
If your Z-Wave certified controller features Remote Access,
you can now control your lighting from your mobile devices
To exclude and reset the device:
1. Follow the instructions for your Z-Wave certified controller to
exclude a device from the Z-Wave network.
2. Once the controller is ready to Exclude your device, press
and release the manual/program button on the smart switch
to exclude it from the network.
Factory reset Plug-in Switch (Dual Plug Simultaneous Control)
To return your switch to factory defaults:
1. If plugged in, unplug the device from the receptacle.
2. Press and hold the top button, plug the device in, and continue to hold for at least 3 seconds.
Note: This should only be used in the event your networks’
primary controller is missing or otherwise inoperable.
Please note that this is a user manual Plug-in Switch (Dual Plug Simultaneous Control) from Honeywell is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Plug-in Switch (Dual Plug Simultaneous Control) and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.