The following is an overview of the user manual for the Z-Wave product T6 Pro Z-Wave Programmable Thermostat (TH6320ZW2003)from Honeywell Home (Resideo). To view other Z-Wave products and manuals from Honeywell follow that link.
Overview
- 3 x AA battery or 24VAC powered
- Easy wiring, easy configuration
- Flexible local thermostat scheduling options
- Attractive look, large Easy-To-Read touchscreen
- Displays and reports ambient temperature and % Relative Indoor Humidity
- Displays and reports HVAC system status, battery power status, Z-Wave signal status
- Large amount of supported Z-Wave command classes
- Remotely configurable via Z-Wave configuration command class
- Advanced HVAC configuration parameters
Security
As a Z-Wave Plus certified product, T6 Pro Z-Wave Programmable Thermostat supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
Honeywell describes T6 Pro Z-Wave Programmable Thermostat as having the following features:
- Thermostat Modes
- Battery Quantity
- Sensors
- Supported Notification Types
- Battery powered using AA batteries
- Color
- Thermostat Power Source
- Thermostat HVAC Systems Supported
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
To exclude the thermostat from Z-Wave network, go to thermostat MENU/ Z-Wave SETUP.
• Touch Select. You will be asked to set your primary
controller to EXCLUDE MODE. Please refer to the user manual of your Z-Wave controller.
• After exclusion procedure has been initiated on your Z-Wave controller, touch Select on the thermostat.
• If the exclusion procedure is successful, ""EXCLUDED"", and the Z-Wave excluded status icon appear on the screen.
If the procedure fails, “FAILED TO EXCLUDE” appears on the screen.
• Your controller will indicate whether the thermostat was successfully excluded from its network. Please refer to the user manual of your Z-Wave controller.
To include the thermostat in to Z-Wave network, go to thermostat MENU/ Z-Wave SETUP.
• Touch Select. You will be asked to set your primary controller to INCLUDE MODE. Please refer to the user manual of your Z-Wave controller.
• After inclusion procedure has been initiated on your Z-Wave controller, touch Select on the thermostat.
• If the inclusion procedure is successful, ""INCLUDED"", the node ID, and the Z-Wave connected status icon appear on the screen.
If the procedure fails, “FAILED TO INCLUDE” appears on the screen.
• Your controller will indicate whether the thermostat was successfully added to its network. Please refer to the user manual of your Z-Wave controller.
Factory reset T6 Pro Z-Wave Programmable Thermostat
To reset the thermostat to factory default setting, go to Installer setup – advanced menu. To access the advanced menu, press and hold the thermostat Menu button for 5 seconds.
Touch < or > to go to RESET menu. Press Select. Touch < or > to go to FACTORY. Press Select. Touch Yes to reset the thermostat to factory default settings..
Please use the reset procedure only when the primary controller is missing or inoperable.
Please note that this is a user manual T6 Pro Z-Wave Programmable Thermostat from Honeywell Home (Resideo) is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have T6 Pro Z-Wave Programmable Thermostat and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.