The following is an overview of the user manual for the Z-Wave product Digital Mortise Door Lock (HU04)from Hugolog powered by KAADAS. To view other Z-Wave products and manuals from Hugolog powered by KAADAS follow that link.
Overview
This product can be operated in any Z-Wave network with other Z-Wave certified products from other manufacturers.
All mains operated nodes within the network will act as repeaters regardless of vendor to increase reliability of the network.
This product supports the Over The Air (OTA) feature for the product's firmware upgrade.
Security
As a Z-Wave Plus certified product, Digital Mortise Door Lock supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Access Control
Features
Hugolog powered by KAADAS describes Digital Mortise Door Lock as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- Battery Quantity
- Battery powered using AA alkaline battery batteries
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
SmartStart location
SmartStart QR code's location as follows: You can find the QR code and DSK on back side of module.
Join a network: inclusion Z-Wave network and add the lock.
1.Follow the user guide of hub to enter inclusion mode.
2.Operate on lock following guide below:
3.Enter master mode(** + Master PIN Code + #), Wait for 2 Green Lights + 2 Beeps
4.Input “8+1+#” to enter “Inclusion mode” (2 Green Lights + 2 Beeps)
Log off a network: Exclusion Z-Wave network and remove the lock
1.Follow the user guide of hub to enter exclusion mode.
2.Operate on lock following guide below:
3.Enter master mode(** + Master PIN Code + #), Wait for 2 Green Lights + 2 Beeps
4.Input “8+2+#” to enter “Exclusion mode”(2 Green Lights + 2 Beeps)
Not Applicatable
Factory reset Digital Mortise Door Lock
Factory reset:
1.Operations on lock
2.Open the door and keep the lock in "unlock" status
3.Open battery box and find the reset button.
4.Use a sharp thing to press and hold the reset button.
5.Keep holding the reset button for 5 seconds until hearing voice guide.
Please note that this is a user manual Digital Mortise Door Lock from Hugolog powered by KAADAS is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Digital Mortise Door Lock and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.