v3 Window Blind Motor (IB3.0) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product v3 Window Blind Motor (IB3.0)from iBlinds. To view other Z-Wave products and manuals from iBlinds follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions


iblinds v3 Window Blind Motor
SKU Code
iblinds is a simple Z-Wave Plus device used to automate your existing window blinds. You can control any 2-2 ½ inch corded lift horizontal blinds in your home or office. Set a scheduled to open at sunrise and close at sunset, use voice control with Amazon Alexa and Google Home or manually control a single blind, or a group of them, from home or anywhere in the world with one touch of a button using your smartphone, tablet or Z-Wave remote.
Version #
HW: 1 FW: 3.01 was the version certified
Certification #
Z-Wave Version


As a Z-Wave Plus certified product, v3 Window Blind Motor supports Z-Wave S2 security. The following security modes are directly supported:

  • S2 Authenticated
  • S2 Unauthenticated


iBlinds describes v3 Window Blind Motor as having the following features:

  • Battery Quantity
  • Window Covering Control Features
  • Battery powered using Rechargeable Lithium Ion batteries
  • Firmware updatable via a compatible Z-Wave gateway
  • FLiRS capable
  • Supports Network Wide Inclusion
  • Supports Z-Wave Explorer Frames
  • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

Installation instructions

Press the exclude (IN/EX) button 3 times and wait for the device to be removed from the Z-Wave network.


Factory reset v3 Window Blind Motor

Press the IN/EX button 5 times for Device Reset Locally (Factory Reset)


SmartStart location

SmartStart QR code's location as follows: The DSK can be found on the bottom of the iblinds motor, the packaging and, on the back page of this Quick Start Guide.

Press the inclusion (IN/EX) button 3 times and wait for the device to be discovered and joined to the Z-Wave network. Follow the directions for your Z-Wave controller to uniquely identify your device. (Ex: Bedroom iblinds)

Wake-up commands are handled by the Controller, this is a FLiRS device

Please note that this is a user manual v3 Window Blind Motor from iBlinds is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have v3 Window Blind Motor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.