The following is an overview of the user manual for the Z-Wave product Window Blind Controller (IB2.0)from iBlinds. To view other Z-Wave products and manuals from iBlinds follow that link.
Overview
Security
As a Z-Wave Plus certified product, Window Blind Controller supports Z-Wave S2 security. The following security modes are directly supported:
Features
iBlinds describes Window Blind Controller as having the following features:
- Battery Quantity
- Battery powered using Rechargeable Li-ion batteries
- Color
- Window Covering Control Features
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Follow the directions for your Z-Wave hub/controller to place it in the add for inclusion mode.
Press the inclusion button once and wait for the device to be discovered and joined to the Z-Wave network. Follow the directions of your Z-Wave controller to uniquely identify your iblinds device. (Ex: Bedroom iblind)
Note: If the device is not joined to the network. Press the CLBR button Wait 1 minutes and repeat steps 1 and 2 again. If you continue to have trouble joining the iblinds motor to the Z-Wave network follow the Z-Wave network Exclusion process below.
Follow the directions for your Z-Wave device to place it in the exclusion mode.
Press the exclude button once and wait for the device to be removed from the Z-Wave network.
Factory reset Window Blind Controller
The Device Reset Locally function is used to reset the device to fatory defalut. The reset operation resets protocol data (HomeID, NodeID) as well as all application specific data to factory default values.vice Reset Locally
NOTE: Please only use this function when the primary controller is missing or inoperable!
1. Press the INC / EXC button 3
Press the INC / EXC button 3 times within 5 seconds to enable the device reset function.
2. Wait 30 Seconds Press CLBR button
After device is reset wait 30 seconds and press the CLBR button to reboot the device and make it ready for Z-Wave Inclusion.
Please note that this is a user manual Window Blind Controller from iBlinds is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Window Blind Controller and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.