The following is an overview of the user manual for the Z-Wave product One Link (CH-1000)from iControl Networks. To view other Z-Wave products and manuals from iControl Networks follow that link.
Overview
Security
As a Z-Wave Plus certified product, One Link supports Z-Wave S2 security. The following security modes are directly supported:
Features
iControl Networks describes One Link as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
To exclude another Z-Wave product, log into the Icontrol user interface and select ""Manage Devices"". Then select ""Z-Wave"". From the Z-Wave screen, select ""Reset"". Perform the necessary steps on the targeted Z-Wave device to exclude it from the system.
To include another Z-Wave product, log into the Icontrol user interface and select ""Manage Devices"". Then select ""Z-Wave"". From the Z-Wave screen, select ""Add Z-Wave"". Perform the necessary steps on the targeted Z-Wave device to add it to the system.
To include another Z-Wave product, log into the Icontrol user interface and select ""Manage Devices"". Then select ""Z-Wave"". From the Z-Wave screen, select ""Add Z-Wave"". Perform the necessary steps on the targeted Z-Wave controller to add it to the network.
Factory reset One Link
To reset the One Link to factory defaults, push and hold the ""Reset"" button for at least 15 seconds (or until all LED's begin flashing simultaneously). Note: resetting your One Link will remove it and all associated devices from your Icontrol system.
Please note that this is a user manual One Link from iControl Networks is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have One Link and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.