The following is an overview of the user manual for the Z-Wave product 101 (ID-101)from ID Lock. To view other Z-Wave products and manuals from ID Lock follow that link.
Overview
It enables your ID Lock to operate in a Z-Wave network with numerous access control funtions and notifications.
Security
As a Z-Wave Plus certified product, 101 supports Z-Wave S2 security. The following security modes are directly supported:
Features
ID Lock describes 101 as having the following features:
- Door Lock Type
- Firmware updatable via a compatible Z-Wave gateway
- IP (Ingress Protection) Rated
- Outdoor Use
- Sensors
- Supported Notification Types
- Battery Quantity
- Battery powered using AA batteries
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Activate by touching numpad with two fingers or handpalm
Notification parameter in COMMAND_CLASS_NOTIFICATION_V4
Events:
- Manual Unlock Operation (0x02)
- Remote Unlock Operation (0x04)
- Keypad Unlock Operation (0x06)
- Unlock Request by Unknown User Code (0x014)
- Forced Open Alarm (0x03)
- Fire Alarm (0x0A)
Inclusion – (Puts your device in inclusion mode)
• Push and hold button until all LEDs on keypad activates. (with ID Lock in an unlocked state)
• Release button and press “8” on keypad.
Inclusion mode starts immediately. LED indicator below logo signals this by flashing blue.
Factory reset 101
Device reset – (This will reset RF interface module to factory default settings)
Warning: Please do only proceed with the following reset procedure, if primary network controller is missing or otherwise
inoperable.
RESET Z-WAVE MODULE:
Activate doorlock service menu, by holding inside push button for 5sec while door is in OPEN state.
Outside touchpanel activates > Push ""0""
FACTORY RESET DOORLOCK FIRMWARE:
1. Push innside pushbutton continously for five Seconds after inserting batteries.
2. Receive reset sound
3. Receive confirmation sound
Exclusion – (Puts your device in exclusion mode)
• Push and hold button until all LEDs on keypad activates. (with ID Lock in an unlocked state)
• Release button and press “8” on keypad.
Exclusion mode starts immediately. LED indicator below logo signals this by flashing blue.
Please note that this is a user manual 101 from ID Lock is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have 101 and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.