The following is an overview of the user manual for the Z-Wave product In-Wall Smart Dimmer (61303/ZW3010)from iDevices. To view other Z-Wave products and manuals from iDevices follow that link.
Overview
Security
As a Z-Wave Plus certified product, In-Wall Smart Dimmer supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
iDevices describes In-Wall Smart Dimmer as having the following features:
- Electric Load Type
- Firmware updatable via a compatible Z-Wave gateway
- Neutral Wire Required
- Switch Load Capacity Watts
- Switch Type
- Z-Wave Scene Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
SmartStart location
SmartStart QR code's location as follows: Page 1 Section 4.
NOTE: SmartStart enabled products can be added into a Z-Wave network
by scanning the QR code on the product with a controller providing
SmartStart inclusion. No further action is required and the SmartStart
product will be added automatically within
Adding your device to a Z-Wave network
1. Follow the instructions for your Z-Wave certified controller to
add a device to the Z-Wave network.
2. Once the controller is ready to add your device, press
and release the top or bottom of the wireless smart dimmer
(rocker).
To remove and reset the device
1. Follow the instructions for your Z-Wave certified controller to
remove a device from the Z-Wave network.
2. Once the controller is ready to remove your device, press
and release the top or bottom of the wireless smart dimmer
(rocker).
Factory reset In-Wall Smart Dimmer
1. Quickly press ON (top) button three times then immediately
press the OFF (bottom) button three times. The LED will flash
ON/OFF five times when completed successfully.
Note: This should only be used if your network’s primary
controller is missing or otherwise inoperable.
Please note that this is a user manual In-Wall Smart Dimmer from iDevices is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have In-Wall Smart Dimmer and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.