The following is an overview of the user manual for the Z-Wave product In-Wall Smart Switch (61301/ZW4008)from iDevices. To view other Z-Wave products and manuals from iDevices follow that link.
Overview
Security
As a Z-Wave Plus certified product, In-Wall Smart Switch supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
iDevices describes In-Wall Smart Switch as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- Neutral Wire Required
- Switch Load Capacity Current
- Switch Load Capacity Watts
- Switch Type
- Z-Wave Scene Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
SmartStart location
SmartStart QR code's location as follows: Page 1 of Section 4.
If prompted by the controller to enter the S2 security code, refer to the QR
code/security number on the side of the box or the QR code label on the
product (see Figure 1). Enter the 5-digit code.
Adding your device to a Z-Wave network
1. Follow the instructions for your Z-Wave certified
controller to add a device to the Z-Wave network.
2. Once the controller is ready to add your device, press the
top or bottom of the wireless smart switch (rocker).
To remove and reset the device
1. Follow the instructions for your Z-Wave certified controller
to remove a device from the Z-Wave network.
2. Once the controller is ready to remove your device, press
the top or bottom of the wireless smart switch (rocker).
To return your switch to factory defaults
1. Quickly press ON (top) button three times, then, immediately
press the OFF (bottom) button three times. The LED will
flash ON/OFF five times when completed successfully.
Note: This should only be used if your network’s primary controller is
missing or otherwise inoperable.
Factory reset In-Wall Smart Switch
To return your switch to factory defaults
1. Quickly press ON (top) button three times, then, immediately
press the OFF (bottom) button three times. The LED will
flash ON/OFF five times when completed successfully.
Note: This should only be used if your network’s primary controller is
missing or otherwise inoperable.
Please note that this is a user manual In-Wall Smart Switch from iDevices is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have In-Wall Smart Switch and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.