The following is an overview of the user manual for the Z-Wave product In-Wall Tamper Resistant Smart Outlet (61304/ZW1002)from iDevices. To view other Z-Wave products and manuals from iDevices follow that link.
Overview
Security
As a Z-Wave Plus certified product, In-Wall Tamper Resistant Smart Outlet supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
iDevices describes In-Wall Tamper Resistant Smart Outlet as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- Neutral Wire Required
- Switch Load Capacity Current
- Switch Load Capacity Watts
- Switch Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
SmartStart location
SmartStart QR code's location as follows: Page 1 section 4.
If prompted by the controller to enter the S2 security code, refer to the QR code/security
number on the side of the box or the QR code label on the product (see Figure 1). Enter the
5-digit pin code.
Adding your device to a Z-Wave network
1. Follow the instructions for your Z-Wave certified controller to add a device to the Z-Wave
network.
2. Once the controller is ready to add your device, press and release the program button.
To remove and reset the device
1. Follow the instructions for your Z-Wave certified controller to remove a device from
the Z-Wave network.
2. Once the controller is ready to remove your device, press and release program
button of the smart outlet.
Factory reset In-Wall Tamper Resistant Smart Outlet
To return your switch to factory defaults
Press the program button five times, then press the program butotn for at least three seconds.
The LED will blink five times to confirm.
NOTE: This should only be used in the event your networks’ primary controller is missing or
otherwise inoperable.
Please note that this is a user manual In-Wall Tamper Resistant Smart Outlet from iDevices is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have In-Wall Tamper Resistant Smart Outlet and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.