The following is an overview of the user manual for the Z-Wave product Magnetic Contact (HO-09ZW)from IHORN. To view other Z-Wave products and manuals from IHORN follow that link.
Overview
Security
As a Z-Wave Plus certified product, Magnetic Contact supports Z-Wave S2 security. The following security modes are directly supported:
Features
IHORN describes Magnetic Contact as having the following features:
- Supported Notification Types
- Battery powered using CR2450 batteries
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
For Exclusion a network: Put the Z-Wave Interface Controller into “Exclusion” mode, and following its instruction to exclude magnetic contact from your Z-Wave controller.
1. Pressing the anti-tamper switch Triple then enter exclusion mode.
2. Red LED will blink three times when exclusion of the network is successful.
Factory reset Magnetic Contact
Press the anti-tamper switch five times to reset.
Note: Use this procedure only in the event that the primary controller is lost.
Press the anti-tamper switch once to wakeup the product.
For Inclusion to a network: Put the Z-Wave Interface Controller into “Inclusion” mode, and following its instruction to include HO-09ZB to your controller. This magnetic contact needs to be included before installation.
1. Pull out the insulating strip, making the device power on.
2. Pressing the anti-tamper switch three times.
3. Red LED will blink three times while inclusion the network successful
4. If inclusion failed, the sensor will go into sleep mode. To wake the sensor again, you need to use magnet or anti-tamper switch to trigger an inclusion process, and then sensor will repeat steps from 3 to 4.
Please note that this is a user manual Magnetic Contact from IHORN is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Magnetic Contact and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.