The following is an overview of the user manual for the Z-Wave product Z-Wave Gateway Controller and hub (HCS-W1001)from IMAZU. To view other Z-Wave products and manuals from IMAZU follow that link.
Overview
These devices communicate with your Z-Wave devices and accessories allowing you to control your home remotely via your phone, computer or other mobile device.
Security
As a Z-Wave Plus certified product, Z-Wave Gateway Controller and hub supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Access Control
- S2 Authenticated
- S2 Unauthenticated
Features
IMAZU describes Z-Wave Gateway Controller and hub as having the following features:
- Supported Notification Types
- Outdoor Use
- Communications Connections
- Controller Supports Multiple Networks
- Firmware updatable via a compatible Z-Wave gateway
- IP (Ingress Protection) Rated
- Sensors
- Color
- Communications Protocol
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
This performs the Z-Wave set learn mode network operation. This can only be performed when Z-Ware is not in a network and will typically make Z-Ware an inclusion or Secondary Controller, in which chase, some of its facilities will not be available.
To complete an S2 inclusion, the DSK may need to be entered on the including Controller.
Note that this function may let ht-host as “secondary controller” or “inclusion controller” in another existing network, just start inclusion mode or controller shift on another controller, then start ht-host learn mode, after inclusion, ht-host will replicate node information from another controller.
Since our design is based on “primary controller”, we recommend that you just use our ht-host as “primary controller”
press iot add device button by plus icon will let into inclusion mode, about 100seconds
User can now trigger the device’s node information frame to add to the hcs-w1001 Z-Wave network.
With Z-Wave security2, user needs to accept or modify the security class setting. It is recommended that the user not change the security class settings.
Additionally for security2 class 1 and 2 devices, the user needs to key in the 1st 5digits of the DSK.
Pressing the “MODIFY IOT DEVICE” will let into exclusion mode, about 100seconds.
User can now trigger the device’s node information frame to remove device from any Z-Wave network.
Factory reset Z-Wave Gateway Controller and hub
This is the Z-Wave Set default network operation and it pops up a confirmation prompt.
If this controller is the primary controller for your network, resetting it will result in the nodes in your network being orphaned and it will be necessary after the reset to exclude and re-include all of the nodes in the network.
If this controller is being used as a secondary controller in the network, use this procedure to reset this controller only in the event that the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual Z-Wave Gateway Controller and hub from IMAZU is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave Gateway Controller and hub and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.