Z-Wave Doorbell Sensor (DB100Z) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Z-Wave Doorbell Sensor (DB100Z)from Ingersoll Rand - Nexia Home Intelligence. To view other Z-Wave products and manuals from Ingersoll Rand / Nexia follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions


Z-Wave Doorbell Sensor
SKU Code
The DB100Z is a battery powered, voltage sensing device that sends out a Notification report when voltage is detected at the sensor inputs.
Version #
01 was the version certified
Certification #
Z-Wave Version


As a Z-Wave Plus certified product, Z-Wave Doorbell Sensor supports Z-Wave S2 security. The following security modes are directly supported:


    Ingersoll Rand / Nexia describes Z-Wave Doorbell Sensor as having the following features:

    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    1. Set primary controller to Exclude mode
    2. Press the Install Button

    When the Install Button is triple-pressed, the device will send a Wakeup Notification report and stay awake for 10 seconds.

    Min Wake Up Interval :60 seconds
    Max Wake Up Interval: 86400 seconds
    Default Wake Up Interval: 25200 seconds
    Wake Up Interval Step: 60

    1. Set primary controller to Include mode
    2. Press the Install Button

    Factory reset Z-Wave Doorbell Sensor

    Please only perform a factory reset when the primary controller is missing or inoperable. A factory reset will remove all network settings and configurations.

    1. Hold down Install Button for 10 seconds
    2. Release the Install Button
    3. When the Status LED begins to blink, the unit has finished restoring configuration

    Please note that this is a user manual Z-Wave Doorbell Sensor from Ingersoll Rand - Nexia Home Intelligence is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave Doorbell Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.