Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

4-in-1 Sensor (LZW60) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product 4-in-1 Sensor (LZW60)from Inovelli. To view other Z-Wave products and manuals from Inovelli follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
4-in-1 Sensor
SKU Code
LZW60
Description
The 4-in-1 sensor is designed for use with scenes in home automation systems, and has motion, light, temperature and humidity readings built in. The sensor can be powered by CR123A battery or USB cable. The Motion Sensor lets you know when movement is detected in a certain area and can trigger different actions in response to that movement (or lack of movement). It also lets you know the ambient temperature and humidity to trigger different actions to make you more comfortable.
Version #
HW: 3 FW: 2.02 was the version certified
Certification #
ZC10-20016857
Certified
2020-01-29T17:32:49.044519
Z-Wave Version
6.81.00

Security

As a Z-Wave Plus certified product, 4-in-1 Sensor supports Z-Wave S2 security. The following security modes are directly supported:

  • S2 Unauthenticated

Features

Inovelli describes 4-in-1 Sensor as having the following features:

  • Battery Quantity
  • Battery powered using CR123A batteries
  • Firmware updatable via a compatible Z-Wave gateway
  • FLiRS capable
  • Supports Network Wide Inclusion
  • Supports Z-Wave Explorer Frames
  • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

Installation instructions

Press the sensor button 1x and the sensor will flash red rapidly. If successful, the sensor will stop flashing and the red light will be solid for 1-2 seconds, followed by the red light turning off. If unsuccessful, the red light will continue to rapidly flash until it times out after 25 seconds

SmartStart location

SmartStart QR code's location as follows: Back of sensor

Put your HUB in Exclusion mode and press the sensor button 1x. Your sensor will rapidly blink, indicating it’s in exclusion mode. When exclusion is successful, the red light will stop blinking, turn solid red and then turn off.

Short press the sensor button 3x within 1.5 seconds

Factory reset 4-in-1 Sensor

You may hold the Sensor Button for 5 seconds or use a certified controller to remove the device from your network to factory default. The sensors red LED will blink fast and then if successful, will turn off.



Only use this procedure in the event that the network primary controller is missing or otherwise inoperable.

Please note that this is a user manual 4-in-1 Sensor from Inovelli is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have 4-in-1 Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.