The following is an overview of the user manual for the Z-Wave product Door/Window Sensor (NZW1201)from Inovelli. To view other Z-Wave products and manuals from Inovelli follow that link.
Overview
This smart sensor is one of the smallest Z-Wave Plus sensors on the market and comes with a battery (CR14250) as well as adhesive to mount. In addition, step by step video and written instructions can be found on our website for easy installation.
Simplifying lives, one smart home product at a time... that's Inovelli.
*Please see our Amazon or our website for compatible HUB's (not all HUB's support temperature reading).
Security
As a Z-Wave Plus certified product, Door/Window Sensor supports Z-Wave S2 security. The following security modes are directly supported:
Features
Inovelli describes Door/Window Sensor as having the following features:
- Battery Quantity
- Battery powered using CR14250 batteries
- Color
- Sensors
- Supported Notification Types
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Factory reset Door/Window Sensor
Please use a certified controller to remove the device from your network to factory default. Or, to manually remove your device, hold down the button for 5 seconds. Only use this procedure in the event that the network primary controller is missing or otherwise inoperable.
Press the button just above the battery.
Manually set the polling time (see instructions for more details).
First put your Z-Wave enabled HUB in inclusion mode. Next, insert the battery and it will automatically connect to your HUB. If it does not automatically connect after 30 seconds, press the manual button three (3) times.
Put your HUB in exclusion mode and press the manual button three (3) times.
Please note that this is a user manual Door/Window Sensor from Inovelli is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Door/Window Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.