The following is an overview of the user manual for the Z-Wave product In-wall Smart Dimmer (NZW31)from Inovelli. To view other Z-Wave products and manuals from Inovelli follow that link.
Overview
In addition, it has scene control enabled, which allows you to double tap the switch to activate a Z-Wave scene. An example would be a bedtime scene, which turns off all lights, locks the door(s) and sets the temperature to 68 degrees.
Simplifying lives, one smart home product at a time... that's Inovelli.
Security
As a Z-Wave Plus certified product, In-wall Smart Dimmer supports Z-Wave S2 security. The following security modes are directly supported:
Features
Inovelli describes In-wall Smart Dimmer as having the following features:
- Switch Load Capacity Watts
- Switch Load Capacity Current
- Neutral Wire Required
- Outdoor Use
- Z-Wave Scene Type
- Switch Load Capacity Volt-Ampere
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Factory reset In-wall Smart Dimmer
Please use your controller to remove the device from the network. To factory reset, hold the UP button for five (5) seconds when powered on. However, please only use this method if your controller is missing or inoperable.
Primary inclusion method is via, ""Auto-Inclusion"". Start the inclusion process on your HUB/Gateway and then turn the circuit breaker back on to your switch to restore power. You will have 30 seconds before the device times out. The backup method is pressing the Top button on the switch 6 times within 2 seconds.
To exclude, tap the UP/Top button on the switch 6 times within 2 seconds.
Please note that this is a user manual In-wall Smart Dimmer from Inovelli is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have In-wall Smart Dimmer and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.