Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

In-wall Smart Switch (NZW30T) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product In-wall Smart Switch (NZW30T)from Inovelli. To view other Z-Wave products and manuals from Inovelli follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
In-wall Smart Switch
SKU Code
NZW30T
Description
Inovelli's Indoor In-Wall Smart Switch (On/Off) has the ability to turn on and off lights from anywhere in the world. In addition the switch acts as a Z-Wave signal repeater, which amplifies your Z-Wave signal, growing the capabilities of your network.

Simplifying lives, one smart home product at a time... that's Inovelli.
Version #
HW: 1 FW: 20.16 was the version certified
Certification #
ZC10-17115843
Certified
2017-11-09T19:08:38.931433
Z-Wave Version
6.51.07

Security

As a Z-Wave Plus certified product, In-wall Smart Switch supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    Inovelli describes In-wall Smart Switch as having the following features:

    • Z-Wave Scene Type
    • Electric Load Type
    • Switch Load Capacity Current
    • Switch Load Capacity Volt-Ampere
    • Switch Load Capacity Watts
    • Neutral Wire Required
    • Color
    • Switch Type
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    Toggle Up 6 times within 2 seconds.

    Primary inclusion method is via, ""Auto-Inclusion"". Start the inclusion process on your HUB/Gateway and then flip your circuit breaker back on so power is restored to your switch. You will have 30 seconds before the device times out. The backup method is toggling the switch UP 6 times within 2 seconds.

    Factory reset In-wall Smart Switch

    Please use your controller to remove the device from the network. To factory reset, hold up the toggle button (A) for five (5) seconds when powered on. However, please only use this method if your controller is missing or inoperable.

    Please note that this is a user manual In-wall Smart Switch from Inovelli is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have In-wall Smart Switch and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.