The following is an overview of the user manual for the Z-Wave product Light Strip (LZW45)from Inovelli. To view other Z-Wave products and manuals from Inovelli follow that link.
Overview
Security
As a Z-Wave Plus certified product, Light Strip supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Inovelli describes Light Strip as having the following features:
- Outdoor Use
- Z-Wave Scene Type
- Color
- Communications Protocol
- Firmware updatable via a compatible Z-Wave gateway
- IP (Ingress Protection) Rated
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
SmartStart location
SmartStart QR code's location as follows: The QR Code can be found on the back of the controller. (Referenced on Page 1 in the manual)
With your controller in inclusion mode, press the config button (A) 3x.
With your controller in exclusion mode, press the config button (A) 3x.
Factory reset Light Strip
Hold down the config button (A) for 20 seconds.
Please note that this is a user manual Light Strip from Inovelli is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Light Strip and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.