Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

RGBW Smart Bulb (LZW42) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product RGBW Smart Bulb (LZW42)from Ilumin by Inovelli. To view other Z-Wave products and manuals from Inovelli follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
RGBW Smart Bulb
SKU Code
LZW42
Description
With 806 lumens, millions of colors, tunable white, and smooth dimming, this bulb has it all. Best part? It's powered by Z-Wave Plus technology. Imagine walking into a room, tapping a switch (hopefully Inovelli) and your ilumin lights come on to a beautiful movie scene. Or as you're winding down for the night, switch from cool white to warm and gradually dim off the lights as you drift to sleep. These are some of the many things you can do with smart bulbs and we're excited to be able to share them with you.
Version #
HW: 0 FW: 2.25 was the version certified
Certification #
ZC10-19086720
Certified
2019-08-23T20:12:16.080658
Z-Wave Version
6.51.09

Security

As a Z-Wave Plus certified product, RGBW Smart Bulb supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    Inovelli describes RGBW Smart Bulb as having the following features:

    • Firmware updatable via a compatible Z-Wave gateway
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    Start the inclusion process on your HUB/Gateway.
    Once the inclusion process has started, turn on and off power to the bulb 3x (ie: Turn On, Turn Off, Turn On, Turn Off, Turn On) and the bulb should flash 3x indicating it’s in inclusion mode.
    If the bulb was included successfully, it will blink one more time. If it was not included successfully, you may have to run an exclusion as mentioned above. If there’s still issues, please ensure your bulb is within range (Pages 2 & 3).

    If you are having issues pairing/including your device, please ensure your bulb is within range of your HUB (pages 2-3). If you believe you’re within range and it’s still not working, then you may have to run an Exclusion. Put your HUB in Exclusion mode and turn the power on/off/on/off/on/off/on (3x on and 2x off) until your bulb blinks three (3x) and then blinks 1x to confirm. Your HUB should say that the device is excluded. You may then add (include) the bulb per the instructions below.

    Factory reset RGBW Smart Bulb

    You may power on/off the bulb 6x (between 0.5-2 seconds each time) or use a certified controller to remove the device from your network to factory default. Only use this procedure in the event that the network primary controller is missing or otherwise inoperable. Your bulb will flash twice to confirm factory reset.

    Please note that this is a user manual RGBW Smart Bulb from Ilumin by Inovelli is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have RGBW Smart Bulb and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.