Smart Plug (Dimmer) (NZW39) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Smart Plug (Dimmer) (NZW39)from Inovelli. To view other Z-Wave products and manuals from Inovelli follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions


Smart Plug (Dimmer)
SKU Code
Inovelli's Smart Plug-In Dimming Module + Repeater has the ability to dim & turn on and off your lights from anywhere in the world. In addition to the outlet, the smart plug acts as a Z-Wave signal repeater, which amplifies your Z-Wave signal, growing the capabilities of your network.

This smart plug is one of the smallest plugs on the market (3.5"x2.5"x1.5") and has 1 Z-Wave Dimming Outlet on the side of the device allowing for easy fit in compact places. Simplifying lives, one smart home product at a time... that's Inovelli.
Version #
HW: 1 FW: 20.15 was the version certified
Certification #
Z-Wave Version


As a Z-Wave Plus certified product, Smart Plug (Dimmer) supports Z-Wave S2 security. The following security modes are directly supported:


    Inovelli describes Smart Plug (Dimmer) as having the following features:

    • Switch Load Capacity Watts
    • Electric Load Type
    • Color
    • Firmware updatable via a compatible Z-Wave gateway
    • Switch Type
    • Switch Load Capacity Current
    • Neutral Wire Required
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    1. Follow the instructions for your Z-Wave certified controller to include a device to the Z-Wave network.

    2. Once the controller is ready to include your device, quick triple press the button to include it into the network.

    3. Once your controller has confirmed that the device has been included, refresh the Z-Wave network to optimize performance.

    4. The device is associated in the same group when it included in setting process.

    Now you can control your Z-Wave device according to groups, scenes, schedules and automation programmed.

    ** For HUB Specific Instructions, please visit:

    1. Follow the instructions for your Z-Wave certified controller to exclude a device from the Z-Wave network.

    2. Once the controller is ready to Exclude your device, quick triple press the button to exclude it from the network.

    ** For HUB Specific Instructions, please visit:

    Factory reset Smart Plug (Dimmer)

    Use controller to remove device from network will reset it to factory default.

    ""Use this procedure only in the event that the network primary controller is missing or otherwise inoperable.""

    Please note that this is a user manual Smart Plug (Dimmer) from Inovelli is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. only warrants and is only able to support products purchased directly from us. If you have Smart Plug (Dimmer) and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.