The following is an overview of the user manual for the Z-Wave product Smart Plug-In Module (1 Channel) (NZW36)from Inovelli. To view other Z-Wave products and manuals from Inovelli follow that link.
Overview
This smart plug is one of the smallest plugs on the market (3.5"x2.5"x1.5") and has 1 Z-Wave Outlet on the side of the device and an "Always On" (non-smart outlet) on the other side, allowing for easy fit in compact places. Simplifying lives, one smart home product at a time... that's Inovelli.
Security
As a Z-Wave Plus certified product, Smart Plug-In Module (1 Channel) supports Z-Wave S2 security. The following security modes are directly supported:
Features
Inovelli describes Smart Plug-In Module (1 Channel) as having the following features:
- Switch Load Capacity Current
- Neutral Wire Required
- Switch Type
- Color
- IP (Ingress Protection) Rated
- Firmware updatable via a compatible Z-Wave gateway
- Switch Load Capacity Watts
- Electric Load Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1. Follow the instructions for your Z-Wave certified controller to include a device to the Z-Wave network.
2. Once the controller is ready to Include your device, press the center button 3-5 times within 3 seconds.
3. Once your controller has confirmed that the device has been included, refresh the Z-Wave network to optimize performance.
4. The device is associated in the same group when it included in setting process.
Now you can control your Z-Wave device according to groups, scenes, schedules and automation programmed.
** NOTE: If your product does not include at first, try moving the module closer to the HUB and try again -- you can move to your final location when complete
For setup instructions for your specific HUB (ie: SmartThings, Wink, Vera, etc) please go to: www.inovelli.com/nzw36-setup
1. Follow the instructions for your Z-Wave certified controller to exclude a device from the Z-Wave network.
2. Once the controller is ready to Exclude your device, press the center button 3-5 times within 3 seconds to exclude it from the network.
Factory reset Smart Plug-In Module (1 Channel)
Use controller to remove device from network will reset it to factory default.
""Use this procedure only in the event that the network primary controller is missing or otherwise inoperable.""
Please note that this is a user manual Smart Plug-In Module (1 Channel) from Inovelli is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Smart Plug-In Module (1 Channel) and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.