Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

Smart Plug Switch (NZW96) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Smart Plug Switch (NZW96)from Inovelli. To view other Z-Wave products and manuals from Inovelli follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
Smart Plug Switch
SKU Code
NZW96
Description
Inovelli's Outdoor Smart Plug-In On/Off Module + Repeater has the ability to turn on and off appliances, lights, and more from anywhere in the world. In addition to the outlet, the smart plug acts as a Z-Wave signal repeater, which amplifies your Z-Wave signal, growing the capabilities of your network.

This smart plug also is IP65 rated for outdoor use and has 1 Z-Wave Outlet and an "Always On" (non-smart outlet), allowing you to have a remote controlled switch while not losing a non-smart outlet. Simplifying lives, one smart home product at a time... that's Inovelli.
Version #
HW: 0 FW: 20.15 was the version certified
Certification #
ZC10-17105820
Certified
2017-10-27T00:15:28.474973
Z-Wave Version
6.51.06

Security

As a Z-Wave Plus certified product, Smart Plug Switch supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    Inovelli describes Smart Plug Switch as having the following features:

    • Outdoor Use
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    Primary inclusion method is via, ""Auto-Inclusion"". Start the inclusion process on your HUB/Gateway and then plug in the device. You will have 30 seconds before the device times out. The backup method is pressing the button on the front 5 times within 1 second.

    Press the front button 5 times within 1 second.

    Factory reset Smart Plug Switch

    Please use your controller to remove the device from the network. To factory reset, hold down the manual button (A) for five (5) seconds when powered on. However, please only use this method if your controller is missing or inoperable.

    Remembers last power state, high temperature protection, invert LED, disable LED, automatic shutoff after x seconds

    Please note that this is a user manual Smart Plug Switch from Inovelli is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Smart Plug Switch and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.