Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

Hub (Connect2) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Hub (Connect2)from IOTAS. To view other Z-Wave products and manuals from IOTAS follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
IOTAS Hub
SKU Code
Connect2
Description
IOTAS provides its customers (residents, property managers and building owners) with an enterprise software solution that updates your community experience as new hardware and integrations are released. Along with the smart hub IOTAS provides lights, outlets, thermostats, door locks, ceiling fans, sensors and much more. The system allows residents remote access to their home but also delivers powerful solutions to property management for building-wide control and oversight. A complete ecosystem with simple installation using the IOTAS Connect hub for a safe and secure smart infrastructure.
Version #
HW: 1 FW: 6.04:02.81:02.02 was the version certified
Certification #
ZC10-20036880
Certified
2020-03-05T16:45:00.326873
Z-Wave Version
6.81.03

Security

As a Z-Wave Plus certified product, Hub supports Z-Wave S2 security. The following security modes are directly supported:

  • S2 Access Control
  • S2 Authenticated
  • S2 Unauthenticated

Features

IOTAS describes Hub as having the following features:

  • Firmware updatable via a compatible Z-Wave gateway
  • Controller Supports Multiple Networks
  • Color
  • FLiRS capable
  • Supports Network Wide Inclusion
  • Supports Z-Wave Explorer Frames
  • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

Installation instructions

SmartStart location

SmartStart QR code's location as follows: The DSK label can be found on the under side of the hub. It is also available via the IOTAS Maintenance Tool UI. Please see IOTAS Z-Wave Maintenance Tool Documentation (page 9) for details - IOTASZWaveMaintenanceToolDocs.pdf.

Start exclusion, per instructions on the existing network controller.
In the UI, press the learn button.
Verify exclusion completed successfully on the existing network controller per that documentation.

Factory reset Hub

In the UI, press Hard Reset.

Start inclusion, per instructions on the existing network controller.
In the UI, press the learn button.
When prompted, enter the 5 digit underlined portion of the DSK code.
Verify secure inclusion completed successfully on the existing network controller per that documentation.

Please note that this is a user manual Hub from IOTAS is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Hub and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.