The following is an overview of the user manual for the Z-Wave product Door/Window Sensor (JWZH-O-2015-4)from iSurpass. To view other Z-Wave products and manuals from iSurpass follow that link.
Overview
Security
As a Z-Wave Plus certified product, Door/Window Sensor supports Z-Wave S2 security. The following security modes are directly supported:
Features
iSurpass describes Door/Window Sensor as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1, Have Z-Wave controller entered the inclusion mode.
2, Press the tamper switch of the sensor three times within 1.5 seconds.
3, Device added successful.
1, Have Z-Wave controller entered the exclusion mode.
2, Press the tamper switch of the sensor three times within 1.5 seconds.
3, Node has been excluded.
Factory reset Door/Window Sensor
When the sensor is in Z-Wave network, press five times the tamper switch within 1.5 seconds, and do not release the switch at last press until the LED lighting, then the sensor has been set to factory default, please reset the device only when the primary controller is missing or inoperable
Pressing the tamper switch one time within 1.5 seconds, the sensor will wake up and wait for commands from the Z-Wave Controller, then go to sleep again after 10 seconds or sleep immediately when receive wake up no more information command. By default, the sensor wake up one time per 12 hours and can be modified by wake up interval set command.
Please note that this is a user manual Door/Window Sensor from iSurpass is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Door/Window Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.