The following is an overview of the user manual for the Z-Wave product Smart-BRIDGE CL (Smart-BRIDGE CL)from Iwatsu Electric Co., Ltd.. To view other Z-Wave products and manuals from Iwatsu Electric follow that link.
Overview
It compliance with various Z-Wave peripheral equipment such as Motion, Temperature, Humidity etc. for various IoT applications.
Security
As a Z-Wave Plus certified product, Smart-BRIDGE CL supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Access Control
- S2 Authenticated
- S2 Unauthenticated
Features
Iwatsu Electric describes Smart-BRIDGE CL as having the following features:
- Sensors
- Supported Notification Types
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
To add a device to the Z-Wave network, press the hardware Z-WAVE SW of this equipment once in quick (no more than 1 second between). A button on the GUI is also present to start the inclusion(""NWI"" or ""Add"" button).
To remove a device from the Z-Wave network, hold down the hardware Z-WAVE SW of this equipment (over 3 seconds). A button on the GUI is also present to start exclusion(""Start Exclusion"" button).
This equipment can be controlled via the GUI provided.
To add this equipment into another Z-Wave network as a secondary controller or inclusion controller, click “Start Learn Mode” in the GUI provided.
Factory reset Smart-BRIDGE CL
Hold down the hardware INIT SW (over 3 seconds). A button on the GUI is present to start the reset(""Resets the Chip"" button).
If this controller is the primary controller for your network, resetting it will result in the nodes in your network being orphaned and it will be necessary after the reset to exclude and re-include all of the nodes in the network. If this controller is being used as a secondary controller in the network, use this procedure to reset this controller only in the event that the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual Smart-BRIDGE CL from Iwatsu Electric Co., Ltd. is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Smart-BRIDGE CL and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.