The following is an overview of the user manual for the Z-Wave product Z-Wave Extender for Smoke Detection Sensor (NE-SSEN)from Iwatsu. To view other Z-Wave products and manuals from Iwatsu follow that link.
Overview
This equipment extends the Smoke Detection Sensor to Z-Wave correspondence.
Security
As a Z-Wave Plus certified product, Z-Wave Extender for Smoke Detection Sensor supports Z-Wave S2 security. The following security modes are directly supported:
Features
Iwatsu describes Z-Wave Extender for Smoke Detection Sensor as having the following features:
- Battery Quantity
- Battery powered using CR17450 batteries
- Color
- Firmware updatable via a compatible Z-Wave gateway
- IP (Ingress Protection) Rated
- Outdoor Use
- Sensors
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
This equipment can transmit Wake Up Notification by Triple Press the ""Add/Remove Button""
Push ""Add/Remove Button"" of this equipment for a short time.
Push ""Add/Remove Button"" of this equipment for a short time.
Also, if this equipment is NOT Added to any network, it is enable to Add automatically when the battery is connected.
Factory reset Z-Wave Extender for Smoke Detection Sensor
Push and hold ""Add/Remove Button"" for a few seconds more than 5 seconds.
Please use this procedure only when the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual Z-Wave Extender for Smoke Detection Sensor from Iwatsu is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave Extender for Smoke Detection Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.