Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

In-Wall Smart Motion Dimmer (26933) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product In-Wall Smart Motion Dimmer (26933)from Jasco Products Company. To view other Z-Wave products and manuals from Jasco follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
In-Wall Smart Motion Dimmer
SKU Code
26933
Description
Transform any home into a smart home with the GE In-Wall Smart Motion Dimmer. This Z-Wave device replaces you current light switch using your existing wiring and provides Z-Wave wireless control of overhead lighting. The dimmer enables wireless control of On/Off functions of incandescent, LED, xenon, halogen and fluorescent lighting. Not only does it act as a dimmer but the GE In-Wall Smart Motion Dimmer has a built in PIR sensor which can control the local load and be set in occupancy or vacancy mode.

Version #
HW: 255 FW: 5.50 was the version certified
Certification #
ZC10-16125342
Certified
2016-12-12T07:35:06.475071
Z-Wave Version
6.51.08

Security

As a Z-Wave Plus certified product, In-Wall Smart Motion Dimmer supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    Jasco describes In-Wall Smart Motion Dimmer as having the following features:

    • Firmware updatable via a compatible Z-Wave gateway
    • Neutral Wire Required
    • Sensors
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    1. Follow the instructions for your Z-Wave certified
    controller to add the smart dimmer to the Z-Wave
    network.
    2. Once the controller is ready to add your smart
    dimmer, press and release the top or bottom
    button on the smart dimmer to include it in the
    network.

    1. Follow the instructions for your Z-Wave certified
    controller to remove a device from the Z-Wave
    network.
    2. Once the controller is ready to remove your device,
    press and release the top button on the smart
    dimmer to remove it from the network.

    Factory reset In-Wall Smart Motion Dimmer

    Press and release the top button ten times within 5
    seconds. The LED will flash 3 times quickly confirming
    change.
    Note: This should only be used in the event your
    network’s primary controller is missing or otherwise
    inoperable

    Please note that this is a user manual In-Wall Smart Motion Dimmer from Jasco Products Company is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have In-Wall Smart Motion Dimmer and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.