The following is an overview of the user manual for the Z-Wave product In-Wall Smart Outlet (14313/ZW1001)from Jasco Products Company. To view other Z-Wave products and manuals from Jasco follow that link.
Z-Wave is the world’s largest ecosystem of interoperable smart home products. Z-Wave lighting controls provide an easy-to-install and affordable system to control lighting and small appliances in your home. Add GE Z-Wave lighting controls to a Z-Wave certified gateway to access and control your home from anywhere in the world using your smartphone, tablet or computer as a home automation command center. Never worry if you accidentally left the lights on because you can turn them off remotely or program your lights to go on/off at specific times. Create customized lighting scenes for any occasion such as a “go to sleep” scene or a “movie night” scene. Give the illusion that someone is home by programming the lights to turn on/off while you are away—perfect for deterring crime and adding additional security!
As a Z-Wave Plus certified product, In-Wall Smart Outlet supports Z-Wave S2 security. The following security modes are directly supported:
Jasco describes In-Wall Smart Outlet as having the following features:
- Neutral Wire Required
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
1. Follow the instructions for your Z-Wave certified
controller to include a device to the Z-Wave network.
2. Once the controller is ready to include your device, press and
release the Program Button to include it in the network.
3. Once your controller has confirmed that the device has been
included, refresh the Z-Wave network to optimize performance.
1. Follow the instructions for your Z-Wave certified controller to
exclude a device from the Z-Wave network.
2. Once the controller is ready to Exclude your device, press and
release the manual/program button on the smart dimmer to
exclude it from the network.
Factory reset In-Wall Smart Outlet
Press and hold the button for at least 3 seconds. The LED light
will blink 5 times to confirm.
Note: This should only be used in the event your network’s
primary controller is missing or otherwise inoperable.
Please note that this is a user manual In-Wall Smart Outlet from Jasco Products Company is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have In-Wall Smart Outlet and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.