The following is an overview of the user manual for the Z-Wave product Plug-in Smart Switch (Dual Plug with Pass through Outlet) (55250/ZW4104)from Jasco. To view other Z-Wave products and manuals from Jasco follow that link.
Overview
Security
As a Z-Wave Plus certified product, Plug-in Smart Switch (Dual Plug with Pass through Outlet) supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Jasco describes Plug-in Smart Switch (Dual Plug with Pass through Outlet) as having the following features:
- Switch Type
- Firmware updatable via a compatible Z-Wave gateway
- Switch Load Capacity Current
- Switch Load Capacity Watts
- Z-Wave Scene Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
SmartStart location
SmartStart QR code's location as follows: If prompted by the controller to enter the S2 security code, refer to the QR code/security number on the side of the box or the QR code label on the product (see Figure 1).
1. Follow the instructions for your Z-Wave certified controller to add the smart switch to the Z-Wave network.
2. Once the controller is ready to add your smart switch, press and release the manual/program button on the smart switch.
1. Follow the instructions for your Z-Wave certified controller to remove a smart switch from the Z-Wave network.
2. Once the controller is ready to remove your smart switch, press and release the manual/program button on the smart switch.
Factory reset Plug-in Smart Switch (Dual Plug with Pass through Outlet)
1. If plugged in, unplug the smart switch from the receptacle.
2. Press and hold the program button for at least three seconds while you plug the smart switch into a receptacle.
Please note that this is a user manual Plug-in Smart Switch (Dual Plug with Pass through Outlet) from Jasco is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Plug-in Smart Switch (Dual Plug with Pass through Outlet) and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.