The following is an overview of the user manual for the Z-Wave product Thermostat Control Panel (JTB-3005-03)from Jintaobao. To view other Z-Wave products and manuals from Jintaobao follow that link.
Overview
support control cool/heat/fan climate in Z-Wave
system. The desired temperature in the room can be
set locally using the button on the front of the unit. It
works in the same way as a normal room thermostat
with hard wired to the heating source; meanwhile
control is achieved using Z-Wave wireless signals
also. This enables you to control heating times and
schedule zone heating.
This product can be operated in any Z-Wave network
with other Z-Wave certified devices from other
manufacturers. All non-battery operated nodes within
the network will act as repeaters regardless of vendor
to increase reliability of the network.
Security
As a Z-Wave Plus certified product, Thermostat Control Panel supports Z-Wave S2 security. The following security modes are directly supported:
Features
Jintaobao describes Thermostat Control Panel as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- Switch Load Capacity Current
- Switch Load Capacity Volt-Ampere
- Switch Load Capacity Watts
- Neutral Wire Required
- Sensors
- Thermostat HVAC Systems Supported
- Thermostat Modes
- Thermostat Power Source
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Factory reset Thermostat Control Panel
Please use this procedure only when the network primary controller is missing or otherwise inoperable.
Press and hold PB button located on the back side of thermostat
panel for 10 seconds retrieve thermostat panel factory default.
Start master controller add device mode as instruction, press 3 time of PB button located on the back side of thermostat panel in 1.5 second,
LED flash indicator inclusion processing until included or 60 second timeout no detect any master controller.
Start master controller remove device mode as instruction, press 3 time of PB button located on the back side of thermostat panel in 1.5 second, LED flash indicator exclusion processing until excluded or 5 second timeout no detect any master controller.
Please note that this is a user manual Thermostat Control Panel from Jintaobao is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Thermostat Control Panel and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.