The following is an overview of the user manual for the Z-Wave product Smart Plug In Dimmer (IQ Dimmer)from Johnson Controls. To view other Z-Wave products and manuals from Johnson Controls follow that link.
Overview
• Works with incandescent and most dimmable florescent (CFL), or LED lighting
• 700 Series Z-Wave module
• LED to indicate ON/OFF status
• Remotely or manually turns ON or OFF, or DIM lights
• Controls light fixtures up to 300W incandescent and 65W Dimmable LED/CFL
• Z-Wave Plus Certified (QR code on bottom of device)
• Safety tab to secure unit to AC outlet
• Compact design - does not block 2nd AC outlet
• Supports Network Wide Inclusion (through a repeater)
• Works as Z-Wave Repeater
• Create rules to automate lights & scenes
Security
As a Z-Wave Plus certified product, Smart Plug In Dimmer supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Johnson Controls describes Smart Plug In Dimmer as having the following features:
- Color
- Electric Load Type
- Firmware updatable via a compatible Z-Wave gateway
- Outdoor Use
- Switch Load Capacity Current
- Switch Load Capacity Watts
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
SmartStart location
SmartStart QR code's location as follows: Z-Wave Plus Certified with S2 security and SmartStart (QR code on bottom of device)
1. Place your network controller into inclusion mode by following the controller manufacturer's instructions.
2. When the controller is ready, single click the button on the top of the IQ Dimmer. The controller should indicate that the new device was added successfully.
3. Once the IQ Dimmer has been successfully added to your home network, you can move it to the preferred location in the home.
1. Place your network controller into exclusion mode by following the controller manufacturer's instructions.
2. When the controller is ready, single click the button on the top of the IQ Dimmer. The controller should indicate that the new device was added successfully.
3. Once the IQ Dimmer has been successfully added to your home network, you can move it to the preferred location in the home.
Factory reset Smart Plug In Dimmer
If Inclusion still fails after the 2nd attempt, you need to first reset the IQ Dimmer before repeating the above step. The manual reset method is as follows:
1. Unplug the IQ Dimmer from the AC outlet and also unplug the power plug of the appliance from the IQ Dimmer (if plugged in).
2. Press and hold the button on the IQ Dimmer.
3. Plug the IQ Dimmer back into the AC outlet with the button pressed.
Please note that this is a user manual Smart Plug In Dimmer from Johnson Controls is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Smart Plug In Dimmer and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.