The following is an overview of the user manual for the Z-Wave product Smart Plug In Switch (IQ Outlet)from Johnson Controls. To view other Z-Wave products and manuals from Johnson Controls follow that link.
Overview
- Turns ON/OFF incandescent, CFL, or LED lamps, and AC operated electrical appliances
- 700 Series Z-Wave module
- Energy monitoring supported
- LED to indicate ON/OFF status
- Controls appliances up to 15A
- Z-Wave Plus Certified with S2 security and SmartStart (QR code with Z-Wave DSK included)
- Grounded 3-pin AC power receptacle to enhance safety
- Safety tab to secure to outlet
- Compact design - does not block the 2nd AC outlet
- Over-The-Air firmware upgrade available, if supported by controller
- Supports Network Wide Inclusion (inclusion through a repeater), if supported by controller.
- Functions as a Z-Wave signal repeater
Security
As a Z-Wave Plus certified product, Smart Plug In Switch supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Johnson Controls describes Smart Plug In Switch as having the following features:
- Color
- Switch Load Capacity Current
- Switch Load Capacity Watts
- Electric Load Type
- Firmware updatable via a compatible Z-Wave gateway
- Outdoor Use
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
SmartStart location
SmartStart QR code's location as follows: Z-Wave Plus Certified with S2 security and SmartStart (QR code on bottom of device)
1. Place your network controller into inclusion mode by following the controller manufacturer's instructions.
2. When the controller is ready, single click the button on the top of the IQ Outlet. The controller should indicate that the new device was added successfully.
3. Once the IQ Outlet has been successfully added to your home network, you can move it to the preferred location in the home.
1. Place your network controller into exclusion mode by following the controller manufacturer's instructions.
2. When the controller is ready, single click the button on the top of the IQ Outlet. The controller should indicate that the new device was added successfully.
3. Once the IQ Outlet has been successfully added to your home network, you can move it to the preferred location in the home.
Factory reset Smart Plug In Switch
Please use this procedure only when the network primary controller is missing or otherwise inoperable. The manual reset method is as follows:
1. Unplug the IQ Outlet from the AC outlet and also unplug the power plug of the appliance from the IQ Outlet (if plugged in).
2. Press and hold the button on the IQ Outlet .
3. Plug the IQ Outlet back into the AC outlet with the button pressed.
Please note that this is a user manual Smart Plug In Switch from Johnson Controls is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Smart Plug In Switch and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.