The following is an overview of the user manual for the Z-Wave product 4 Channel Relay (JR-4C01)from JR Automation Technology. To view other Z-Wave products and manuals from JR Automation Technology follow that link.
Overview
Security
As a Z-Wave Plus certified product, 4 Channel Relay supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
JR Automation Technology describes 4 Channel Relay as having the following features:
- Loads Controlled
- Neutral Wire Required
- Color
- Firmware updatable via a compatible Z-Wave gateway
- Electric Load Type
- Switch Load Capacity Current
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
To add the device to the Z-Wave network:
1. Keep the device in Z-Wave range.
2. Power the device.
3. Set the main controller in (Security/non-Security Mode) add mode
(see the controller’s manual).
4. Quickly, three times press the Config Button, LED color will change
from Red to Blue.
5. Wait for the adding process to end.
6. Successful adding will be confirmed by the Z-Wave controller’s
Message and LED Colour will change to Green.
To remove the device from the Z-Wave network:
1. Power the device.
2. Set the main controller into remove mode (see the controller’s
manual).
3. Quickly, three times click the Config button LED color will change to
Blue.
4. Wait for the removing process to end.
5. Successful removing will be confirmed by the Z-Wave controller’s message and Red LED color.
Factory reset 4 Channel Relay
Reset procedure allows restoring the device back to its factory settings, which means all information about the Z-Wave controller will be deleted.
1. Press and Hold Config Button for 10 sec until White LED Indication
to start blinking.
2. Release Config button. Now you have 5sec to Reset Device
otherwise it back to Normal Mode.
3. Single Click Config Button.
4. After a few seconds, the device will be restarted, which is signaled
with the red LED indicator color.
NOTE:- Please use this procedure only when the network primary controller is missing or otherwise inoperable.
JR-4C01 is powered using an AC power supply unit so it is always awake.
Please note that this is a user manual 4 Channel Relay from JR Automation Technology is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have 4 Channel Relay and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.