Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

Kantanbutton01 (UVA01A) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Kantanbutton01 (UVA01A)from KDDI CORPORATION. To view other Z-Wave products and manuals from Kddi Corporation follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
KANTANBUTTON01
SKU Code
UVA01A
Description
KANTANBUTTON01 enables prompt access to the pre-defined operations such as turning all lights off, sending emergency notification to family members, and welcoming guests and so on.
Version #
HW: 1 FW: 39.46 was the version certified
Certification #
ZC10-19026369
Certified
2019-01-22T16:52:46.54625
Z-Wave Version
6.71.01

Security

As a Z-Wave Plus certified product, Kantanbutton01 supports Z-Wave S2 security. The following security modes are directly supported:

  • S2 Unauthenticated

Features

Kddi Corporation describes Kantanbutton01 as having the following features:

  • Battery powered using AAA batteries
  • Battery Quantity
  • Firmware updatable via a compatible Z-Wave gateway
  • FLiRS capable
  • Supports Network Wide Inclusion
  • Supports Z-Wave Explorer Frames
  • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

Installation instructions

0. Put Controller into inclusion mode
1. Open battery cover
2. Press and hold the button there
3. LED is turned on after 5 seconds
4. Release the button when the LED is turned on

0. Put Controller into exclusion mode
1. Open battery cover
2. Press and hold the button there
3. LED is turned on after 5 seconds
4. Release the button when the LED is turned on

Factory reset Kantanbutton01

Please excute this reset procedure only when the primary controller is missing or inoperable.
1. Open battery cover.
2. Press and hold the button there
3. LED is turned on after 5 seconds. Keep holding.
4. LET starts blinking after 10 seconds.
5. Release the button when the LED blinks

1. Open battery cover.
2. Press and hold the button there

Please note that this is a user manual Kantanbutton01 from KDDI CORPORATION is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Kantanbutton01 and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.