The following is an overview of the user manual for the Z-Wave product Kasaihouchikiadaptor01 (UFA01A)from KDDI CORPORATION. To view other Z-Wave products and manuals from Kddi Corporation follow that link.
Overview
It is a fully functional Z-Wave® sensor that can detect a variety of dry contact signals, you just need to connection the matched external sensor on it, such as the water level sensor, dry contact switch, dry contact relay and so on. In other words, it can be used if the external sensor is a dry contact.
It is also a security Z-Wave device and supports the Over The Air (OTA) feature for the product’s firmware upgrade.
It can be included and operated in any Z‐Wave network with other Z‐Wave certified devices from other manufacturers and/or other applications. All non‐battery operated nodes within the network will act as repeaters regardless of vendor to increase reliability of the network.
It also supports Security Command Class and has the AES 128 bit security encryption built right in, so a security enabled controller is needed for fully to utilize its function.
Security
As a Z-Wave Plus certified product, Kasaihouchikiadaptor01 supports Z-Wave S2 security. The following security modes are directly supported:
Features
Kddi Corporation describes Kasaihouchikiadaptor01 as having the following features:
- Supported Notification Types
- Firmware updatable via a compatible Z-Wave gateway
- Battery powered using CR123A batteries
- Color
- Battery Quantity
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Press the Action Button once, which will trigger sending out the Wake up notification command; press and hold the Action Button for 3 seconds, which will toggle on/off the Sensor be waked up for 10 minutes.
Turn the primary controller of Z-Wave network into inclusion mode, short press the product’s Action Button that you can find in the back of the product.
Turn the primary controller of Z-Wave network into exclusion mode, short press the product’s Action Button that you can find in back of the product.
Factory reset Kasaihouchikiadaptor01
Press and hold the Action Button that you can find in back of the product for at least 20 seconds and then release. This procedure should only be used when the primary controller is inoperable.
Support ""Over the Air Firmware Updating"" and “Z-Wave Security”.
Please note that this is a user manual Kasaihouchikiadaptor01 from KDDI CORPORATION is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Kasaihouchikiadaptor01 and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.