The following is an overview of the user manual for the Z-Wave product Qua station (KTS31MWA)from KDDI CORPORATION. To view other Z-Wave products and manuals from Kddi Corporation follow that link.
Overview
-It can also import the file stored in the flask deice directly to NAS GW via USB connection.
-The user can watch the recorded video and listen to the music in the streaming playback on his/her smartphone over the home NW and even out of home remotely by au/KDDI LTE NW.
-An IoT function is in the NAS GW as an IoT GW which enables the user to control IoT device from the external NW.
Security
As a Z-Wave Plus certified product, Qua station supports Z-Wave S2 security. The following security modes are directly supported:
Features
Kddi Corporation describes Qua station as having the following features:
- Color
- Communications Connections
- Communications Protocol
- Controller Supports Multiple Networks
- Controller Supports Multiple Z-Wave Interfaces
- Electric Load Type
- Firmware updatable via a compatible Z-Wave gateway
- IP (Ingress Protection) Rated
- Neutral Wire Required
- Outdoor Use
- Switch Load Capacity Current
- Switch Load Capacity Volt-Ampere
- Switch Load Capacity Watts
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Open smartphone apps, press Network Manager, then press ""Inclusion button"" start the learning mode.
Open smartphone apps, press Network Manager, then press ""Exclusion button"" start the learning mode.
Open smartphone apps, press Network Manager, then press ""Initiate button"" start the learning mode.
Factory reset Qua station
This device has a physical button to set the product to the factory default state.
If this controller is the primary controller for your network, resetting it will result in the nodes in your network being orphaned and it will be necessary after the reset to exclude and re-include all of the nodes in the network. If this controller is being used as a secondary controller in the network, use this procedure to reset this controller only in the event that the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual Qua station from KDDI CORPORATION is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Qua station and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.