Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

Door / Window Sensor (KMS-Z10) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Door / Window Sensor (KMS-Z10)from KOCOM. To view other Z-Wave products and manuals from KOCOM follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
Door / Window Sensor
SKU Code
KMS-Z10
Description
This product can be included and operated in any Z-Wave network with other Z-Wave certified devices from other manufacturers and/or other applications. All non-battery operated nodes within the network will act as repeaters regardless of vendor to increase reliability of the network.
Version #
HW: 3 FW: 1.01 was the version certified
Certification #
ZC10-18015980
Certified
2018-01-23T21:23:00.723785
Z-Wave Version
6.71.01

Security

As a Z-Wave Plus certified product, Door / Window Sensor supports Z-Wave S2 security. The following security modes are directly supported:

  • S2 Unauthenticated

Features

KOCOM describes Door / Window Sensor as having the following features:

  • Communications Connections
  • Sensors
  • Supported Notification Types
  • Battery Quantity
  • Color
  • Battery powered using CR2477 batteries
  • FLiRS capable
  • Supports Network Wide Inclusion
  • Supports Z-Wave Explorer Frames
  • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

Installation instructions

 Press & hold inclusion/Exclusion button during 1 seconds when Open Sensor is exclusion status
 Press for 1seconds, LED is turn on
 Open sensor will try inclusion for 15 seconds when button is released.
 If inclusion is successful, LED will blink 3 times with 100ms interval

 Press & hold inclusion/Exclusion button during 1 seconds when Open Sensor is exclusion status
 Press for 1seconds, LED is turn on
 Open sensor will try exclusion when button is released.
 If exclusion is successful, LED will blink 3 times with 100ms interval

Factory reset Door / Window Sensor

 Press & hold inclusion/Exclusion button during 5 seconds.
 LED turn on and LED turn off after 5sec
 Release Inclusion/Exclusion
 Factory reset will be done in 5 seconds and blink 5 times with 100ms interval
※ Please use factory reset only when the network primary controller is missing or otherwise inoperable

 Wake up Notification is transmitted every 30 minutes by default
 Wake up Notification can be changed in controller

Please note that this is a user manual Door / Window Sensor from KOCOM is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Door / Window Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.