Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

PIR Sensor (KAS-Z10) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product PIR Sensor (KAS-Z10)from KOCOM. To view other Z-Wave products and manuals from KOCOM follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
PIR Sensor
SKU Code
KAS-Z10
Description
This product can be included and operated in any Z-Wave network with other Z-Wave certified devices from other manufacturers and/or other applications. All non-battery operated nodes within the network will act as repeaters regardless of vendor to increase reliability of the network.
Version #
HW: 3 FW: 1.01 was the version certified
Certification #
ZC10-18015981
Certified
2018-01-23T21:23:43.628446
Z-Wave Version
6.71.01

Security

As a Z-Wave Plus certified product, PIR Sensor supports Z-Wave S2 security. The following security modes are directly supported:

  • S2 Unauthenticated

Features

KOCOM describes PIR Sensor as having the following features:

  • Battery Quantity
  • Sensors
  • Battery powered using CR2477 batteries
  • Color
  • Supported Notification Types
  • FLiRS capable
  • Supports Network Wide Inclusion
  • Supports Z-Wave Explorer Frames
  • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

Installation instructions

 Press & hold inclusion/Exclusion button during 1 seconds when Open Sensor is exclusion status
 Press for 1seconds, LED is turn on
 Open sensor will try inclusion for 15 seconds when button is released.
 If inclusion is successful, LED will blink 3 times with 100ms interval

 Press & hold inclusion/Exclusion button during 1 seconds when Open Sensor is exclusion status
 Press for 1seconds, LED is turn on
 Open sensor will try exclusion when button is released.
 If exclusion is successful, LED will blink 3 times with 100ms interval

Factory reset PIR Sensor

 Press & hold inclusion/Exclusion button during 5 seconds.
 LED turn on and LED turn off after 5sec
 Release Inclusion/Exclusion
 Factory reset will be done in 5 seconds and blink 5 times with 100ms interval
※ Please use factory reset only when the network primary controller is missing or otherwise inoperable

 Wake up Notification is transmitted every 30 minutes by default
 Wake up Notification can be changed in controller

Please note that this is a user manual PIR Sensor from KOCOM is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have PIR Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.