The following is an overview of the user manual for the Z-Wave product Pir-zwave (IX30-ZWAVE)from KPL MOTION SENSOR. To view other Z-Wave products and manuals from KPL follow that link.
Overview
Security
As a Z-Wave Plus certified product, Pir-zwave supports Z-Wave S2 security. The following security modes are directly supported:
Features
KPL describes Pir-zwave as having the following features:
- Supported Notification Types
- Battery Quantity
- Battery powered using AA batteries
- Sensors
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Factory reset Pir-zwave
Press the anti-tamper switch for 6 times within 2.5 seconds to restore factory settings(Please include a request to use the reset
procedure only when the primary controller is missing or inoperable)
a) Manual Wake-up Quickly press tamper switch once, the PIR sensor will automatically send wake-up information, and there will be 10s after wake-up to receive gateway setting information.
b) Automatic Wake-up Default time of automatic wake-up is 24 hours, and there will be 10s after wake-up to receive gateway setting information, the max automatic report time = 24 hours, minimum=30min
enter the Exclusion Mode of gateway, and press the tamper switch 3 times within 1.5s, then the PIR sensor will be removed after a period of time.
enter the Inclusion Mode of gateway, and press the tamper switch 3 times within 1.5s, then the PIR sensor will stay in enrollment state until successfully enrolled into network or enrollment time out after 30s.
Please note that this is a user manual Pir-zwave from KPL MOTION SENSOR is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Pir-zwave and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.