The following is an overview of the user manual for the Z-Wave product insert module swtich (IMZ6220)from Kuju. To view other Z-Wave products and manuals from Kuju follow that link.
Overview
Security
As a Z-Wave Plus certified product, insert module swtich supports Z-Wave S2 security. The following security modes are directly supported:
Features
Kuju describes insert module swtich as having the following features:
- Loads Controlled
- Neutral Wire Required
- Color
- Outdoor Use
- Switch Type
- Electric Load Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Step 1) Start the gateway in Remove device mode.
Step 2) Trigger module start ""Device Add/Remove"" mode by program button on the module or local switch connected to the module as following:
a) By program button on the module:
Quick pressing the program button 3 times in 1.5 seconds ( LED quick flashing ) to enter “Device Add/Remove” mode. LED lights up for 3 sec to indicate Remove process complete.
b) By switch connected to the module (only available after 10 mins of AC power on ):
● Rocker Switch: Quick toggle channel 1 or channel 2 switch turn on and off 5 times( LED quick flashing ) to enter “Device Add/Remove” mode. LED lights up for 3 sec to indicate Remove process complete.
● Momentary Switch:
Quick pressing channel 1 or channel 2 switch button 5 times ( LED quick flashing ) to enter “Device Add/Remove” mode. LED lights up for 3 sec to indicate Remove process complete.
Factory reset insert module swtich
Press and hold the program button for 10 sec, LED lights up for 3 sec to indicate the factory default reset complete.
Note:Please use this procedure only when the network primary controller is missing or otherwise inoperable.
Advanced Configuration
1、Selection of Switch types
Parameter number Parameter Size Value Description
1 1 00 Momentary switch panel
1 1 FF （default） Rocker switch panel
2、Rocket switch button “on/off location” synchronize with insert module on/off status
Parameter number Parameter Size Value Description
2 1 00 Synchronize
2 1 FF （default） Not Synchronize
3、Default Lighting on/off when power turn on
Parameter number Parameter Size Value Description
3 1 00 Load 1&2: off
3 1 FF（default） Load 1&2:resume last status
Step 1) Start the gateway in Add device mode.
Step 2) Trigger module start ""Device Add/Remove"" mode by program button on the module or local switch connected to the module as following:
a) By program button on the module:
Quick pressing the program button 3 times in 1.5 seconds ( LED quick flashing ) to enter “Device Add/Remove” mode. LED lights up for 3 sec to indicate Add process complete.
b) By switch connected to the module (only available after 10 mins of AC power on ):
● Rocker Switch: Quick toggle channel 1 or channel 2 switch turn on and off 5 times( LED quick flashing ) to enter “Device Add/Remove” mode. LED lights up for 3 sec to indicate Add process complete.
● Momentary Switch:
Quick pressing channel 1 or channel 2 switch button 5 times ( LED quick flashing ) to enter “Device Add/Remove” mode. LED lights up for 3 sec to indicate Add process complete.
Please note that this is a user manual insert module swtich from Kuju is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have insert module swtich and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.