The following is an overview of the user manual for the Z-Wave product Leak Gopher Meter Reader (LGRM-1)from Leak Intelligence, LLC. To view other Z-Wave products and manuals from Leak Intelligence follow that link.
Overview
Security
As a Z-Wave Plus certified product, Leak Gopher Meter Reader supports Z-Wave S2 security. The following security modes are directly supported:
Features
Leak Intelligence describes Leak Gopher Meter Reader as having the following features:
- Color
- Firmware updatable via a compatible Z-Wave gateway
- Supported Meter Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
How to Remove the Leak Gopher Meter Reader from your Z-Wave Controller
- Plug the wall cube power adapter (included) into the receptacle on the bottom of the Leak Gopher Meter Reader marked “12 VDC”. Plug the wall cube into a 110 VAC outlet.
This provides power to the Leak Gopher Meter Reader.
- Configure the Z-Wave Controller to Exclude a device.
- When the Z-Wave Controller is ready to exclude a device, it will display a message like
“waiting to exclude device. Press exclude button on the device”
- The Include/Exclude button is the Z-Wave logo located on the front of the Leak Gopher Meter Reader.
- Press the Include/Remove button. Depending on your controller you may have to press the button 3 times.
- The Z-Wave Controller will acknowledge that the Leak Gopher Meter Reader has been excluded from the Z-Wave network.
- Your Leak Gopher Meter Reader is excluded from this controller.
Factory reset Leak Gopher Meter Reader
How to reset the Leak Gopher Meter Reader
- If the exclusion process above is not working or the Z-Wave controller that was originally joined to is lost or not available, the following process can be used to factory reset the device to the same state it has when shipped new.
- To reset the Leak Gopher Meter Reader Z-Wave radio and routing tables, press and hold the Include/Exclude button located on the front of the Leak Gopher Meter Reader for 15 seconds.
How to Add the Leak Gopher Meter Reader to your Z-Wave Controller
- Plug the wall cube power adapter (included) into the receptacle on the bottom of the Leak Gopher marked “12 VDC”. Plug the wall cube into a 110 VAC outlet.
This provides power to the Leak Gopher.
- Configure the Z-Wave Controller to Include/Add a device.
- When the Z-Wave Controller is ready to include/add a device, it will display a message like “waiting to add device”. Press Include/Add button on the front of the device.
- The Include/Exclude button is the Z-Wave logo located on the front of the Leak Gopher Meter Reader.
- Press the Include/Remove button. Depending on your controller you may have to press the button 3 times.
- The Z-Wave Controller will acknowledge that the Leak Gopher Meter Reader has been added to the Z-Wave network.
- Your Leak Gopher Meter Reader is ready to use.
Please note that this is a user manual Leak Gopher Meter Reader from Leak Intelligence, LLC is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Leak Gopher Meter Reader and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.