The following is an overview of the user manual for the Z-Wave product A19 Led Bulb Dimmable (6VB-A806ST-Q1R)from LEEDARSON. To view other Z-Wave products and manuals from Leedarson follow that link.
Overview
With all of our lighting, and the app that supports it, you can group lights together, set different lighting scenes for different groups and set schdules to autotmatically turns lights, and groups, on and off. Not only does this give you tremendous lighting flexibility, but it’s great for security purposes. Automatically turning your lights on and off when you’re away, gives the impression you are actually home and this will help deter unwanted entry.
Our connected lighting has the additional option for what we call Saved State. Saved State allows you to save an actual light setting in the bulb itself. This means that when you lose power, the lights will not come back on to the standard, blaring 2700K at full bright. The Saved State will allow the lights to come back on to the nice setting you’ve previously saved.
LEEDARSON stays on the cutting edge of technology and innovation. That’s because they have a responsibility to their customers. That’s because at LEEDARSON, “We build your success in IoT.”
Security
As a Z-Wave Plus certified product, A19 Led Bulb Dimmable supports Z-Wave S2 security. The following security modes are directly supported:
Features
Leedarson describes A19 Led Bulb Dimmable as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- Communications Protocol
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1. Screw the DIM bulb into a standard E26 socket.
2. Turn on the bulb with your wall switch to apply power to the bulb.
a) If you’re not using a wall switch, then use your alternate method to apply power to the bulb.
3. Activate the“included/excluded “ mode on your Z-Wave controller or gateway.
a) This may also be done through your associated app,if your ecosystem has that capability.
4. Toggle the wall-switch, from OFF, then to ON.
a) Or use your alternate method to toggle power from OFF, then to ON.
5. The LED bulb will flash once if it has been successfully “included/excluded “into your Z-Wave network.
1. Screw the DIM bulb into a standard E26 socket.
2. Turn on the bulb with your wall switch to apply power to the bulb.
a) If you’re not using a wall switch, then use your alternate method to apply power to the bulb.
3. Activate the“included/excluded “ mode on your Z-Wave controller or gateway.
a) This may also be done through your associated app,if your ecosystem has that capability.
4. Toggle the wall-switch, from OFF, then to ON.
a) Or use your alternate method to toggle power from OFF, then to ON.
5. The LED bulb will flash once if it has been successfully “included/excluded “into your Z-Wave network.
Factory reset A19 Led Bulb Dimmable
Physically switch the bulb on and off six (6) times for intervals of 0.5-2seconds. After the 6thtime, the bulb will flash twice indicating that it’s successfully reset. Please use this procedure only when the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual A19 Led Bulb Dimmable from LEEDARSON is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have A19 Led Bulb Dimmable and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.