The following is an overview of the user manual for the Z-Wave product A19 Led Bulb Rgbw (6VB-A806ST-Q1G)from LEEDARSON. To view other Z-Wave products and manuals from Leedarson follow that link.
Overview
With all of our lighting, and the app that supports it, you can group lights together, set different lighting scenes for different groups and set schdules to autotmatically turns lights, and groups, on and off. Automatically turning your lights on and off when you’re away, gives the impression you are actually home and this will help deter unwanted entry.
Security
As a Z-Wave Plus certified product, A19 Led Bulb Rgbw supports Z-Wave S2 security. The following security modes are directly supported:
Features
Leedarson describes A19 Led Bulb Rgbw as having the following features:
- Communications Protocol
- Firmware updatable via a compatible Z-Wave gateway
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1. Screw the RGBW bulb into a standard E27 socket.
2. Turn on the bulb with your wall switch to apply power to the bulb.
a) If you’re not using a wall switch, then use your alternate method to apply power to the bulb.
3. Activate the “included/excluded” mode on your Z-wave controller or gateway.
a) This may also be done through your associated app, if your ecosystem has that capability.
4. Toggle the wall-switch, from OFF, then to ON.
a) Or use your alternate method to toggle power from OFF, then to ON.
5. The LED bulb will flash once if it has been successfully “included/ excluded” into your Z-Wave network.
Note: If you are using 3rdparty Z-Wave Controller or Gateway, please refer to 3rdParty’s instruction on how to add a new device to your network.
Note 2: If the bulb will not join the network after repeated attempts, please use the Factory Reset procedures to clear the bulb’s settings.
Factory reset A19 Led Bulb Rgbw
Physically switch the bulb on and off six (6) times for intervals of 0.5-2 seconds. After the 6th time, the bulb will flash twice indicating that it’s successfully reset.
Please use this procedure only when the network primary controller is missing or otherwise inoperable.
1. Screw the RGBW bulb into a standard E27 socket.
2. Turn on the bulb with your wall switch to apply power to the bulb.
a) If you’re not using a wall switch, then use your alternate method to apply power to the bulb.
3. Activate the “included/excluded” mode on your Z-wave controller or gateway.
a) This may also be done through your associated app, if your ecosystem has that capability.
4. Toggle the wall-switch, from OFF, then to ON.
a) Or use your alternate method to toggle power from OFF, then to ON.
5. The LED bulb will flash once if it has been successfully “included/ excluded” into your Z-Wave network.
Note: If you are using 3rdparty Z-Wave Controller or Gateway, please refer to 3rdParty’s instruction on how to add a new device to your network.
Note 2: If the bulb will not join the network after repeated attempts, please use the Factory Reset procedures to clear the bulb’s settings.
Please note that this is a user manual A19 Led Bulb Rgbw from LEEDARSON is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have A19 Led Bulb Rgbw and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.