The following is an overview of the user manual for the Z-Wave product Arrival Sensor (6aB-SS-AG-C0)from LEEDARSON. To view other Z-Wave products and manuals from Leedarson follow that link.
Overview
Security
As a Z-Wave Plus certified product, Arrival Sensor supports Z-Wave S2 security. The following security modes are directly supported:
Features
Leedarson describes Arrival Sensor as having the following features:
- Battery Quantity
- Firmware updatable via a compatible Z-Wave gateway
- Battery powered using Li Battery batteries
- Supported Notification Types
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1. Set the Z-Wave network main controller into learning mode.
2. Triggering this action button.
3. If the add for inclusion is successful, the LED will blink less than 5 seconds and then keep on 3 seconds. Otherwise, the LED will blink 8 seconds and then turn off, in which case you need to repeat the process from step 2.
Factory reset Arrival Sensor
Press and hold more than 5 seconds,led will keep on until the Z-Button is released; Arrival Sensor will send “Device_Reset_Locally” to the main controller and exclude from the Z-Wave network when the Z-Button is released, this procedure will reset the Sensor to factory default.
Please use this procedure only when the network primary controller is missing or otherwise inoperable.
1. Set the Z-Wave network main controller into learning mode.
2. Triggering this action button.
3. If the remove for exclusion, the LED will turn off within 1 second. Otherwise, the LED will blink 8 seconds and then turn off, in which case you need to repeat the process from step 2.
Press the study key three times then the Arrival sensor sending Wake Up Notification to Gateway to report it was wake up. Please make sure the Arrival Sensor is added to the Z-wave network.
Please note that this is a user manual Arrival Sensor from LEEDARSON is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Arrival Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.