The following is an overview of the user manual for the Z-Wave product Bypass Door Window Sensor Z-Wave 700 (7AA-SS-VE-C0)from LEEDARSON. To view other Z-Wave products and manuals from Leedarson follow that link.
Overview
Security
As a Z-Wave Plus certified product, Bypass Door Window Sensor Z-Wave 700 supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Leedarson describes Bypass Door Window Sensor Z-Wave 700 as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
SmartStart location
SmartStart QR code's location as follows: on the side of product
1. Power on your Door Sensor, and let the Z-Wave primary controller into remove/exclusion mode.
2. Trigger this action.
3. LED will flash red during the exclusion, and then solid red for 2 seconds to indicate that the exclusion is successful, otherwise the LED will solid green for 2 seconds in which you need to repeat the process form step 2.
pls chekc the user manual on page 9
NA
Factory reset Bypass Door Window Sensor Z-Wave 700
Reset Contact Sensor to factory default.
NOTE:
1. Triggering this action, the red LED will be accelerate blink in 5 seconds. After 5 seconds, the red LED will remain on until the key is released. Contact Sensor will send “Device_Reset_Locally” to the main controller and exclude from the Z-Wave network when the button is released, this procedure will reset the sensor to factory default.
2. Please use this procedure only when the network primary controller is missing or otherwise inoperable.
3. When not in the network, triggering this action, the red LED will be accelerate blink in 5 seconds. After 5 seconds, the red LED will remain on until the key is released, this procedure will reset the sensor to factory default.
1. Power on your Door Sensor, set your Z-Wave controller into add/inclusion mode.
2. Trigger this action
3. LED will flash green during the inclusion, and then solid green for 2 seconds to indicate the inclusion is successful, otherwise the LED will solid red for 2 seconds in which you need to repeat the process form step 2
Power on: In the network: Send Battery report and Wake up notification, the LED will solid green within 1 second.
Not in the network: Only the LED will blink red for three times and then off.
Short press button one time : In the network: Send Wake up notification, and green LED will fast blink when sending data, and turn off once send completed. But if it don’t receive ack from gateway, the green led will blink for 10 seconds.
Not in the network: NOP
Please note that this is a user manual Bypass Door Window Sensor Z-Wave 700 from LEEDARSON is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Bypass Door Window Sensor Z-Wave 700 and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.