The following is an overview of the user manual for the Z-Wave product Door/Window Sensor (7A-SS-VE-H0)from LEEDARSON. To view other Z-Wave products and manuals from Leedarson follow that link.
Overview
Security
As a Z-Wave Plus certified product, Door/Window Sensor supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Leedarson describes Door/Window Sensor as having the following features:
- Battery Quantity
- Battery powered using CR batteries
- Firmware updatable via a compatible Z-Wave gateway
- Sensors
- Supported Notification Types
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Add for inclusion:
1). Insert the battery.
2). Set the Z-Wave network main controller into learning mode.
3). Triggering this action button.
4). If the add for inclusion is successful, the LED will blink fast and then keep on 3 seconds. Otherwise, the LED will blink 25 seconds and then turn off, in which case you need to repeat the process from step
Remove for exclusion;
1. Insert the CR battery.
2. Set the Z-Wave network main controller into exclusion mode.
3. Triggering this action button.
If the remove for exclusion is successful, the LED will blink fast and turn off. Otherwise, the LED will keep solid for 2 seconds and then turn off, in which case you need to repeat the process from step 2.
Factory reset Door/Window Sensor
LED will blink fast for 5 seconds and then keep solid for 3 seconds, after that Door/Window Sensor will send “Device_Reset_Locally” to the main controller and exclude from the Z-Wave network.
Please use this procedure only when the network primary controller is missing or otherwise inoperable.
1. Short press 3 time.
2. LED will blink one time; sending wake up notification cc
Please note that this is a user manual Door/Window Sensor from LEEDARSON is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Door/Window Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.