The following is an overview of the user manual for the Z-Wave product EU Smart Plug (6A-PL-VAB-C0)from LEEDARSON. To view other Z-Wave products and manuals from Leedarson follow that link.
Overview
Smart Plug is also a security Z-Wave device and supports the Over The Air (OTA) feature for the product’s firmware upgrade.
If you want your Smart Plug to be a security device that use secure/encrypted message to communicate in a Z-Wave network, then a security enabled Z-Wave controller is needed.
Security
As a Z-Wave Plus certified product, EU Smart Plug supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
Leedarson describes EU Smart Plug as having the following features:
- Z-Wave Scene Type
- Supported Meter Type
- Switch Type
- Firmware updatable via a compatible Z-Wave gateway
- Switch Load Capacity Watts
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1. Set the Z-Wave network main controller into learning mode.
2. Short press the Z-button twice
3. The LED keep blink to the end of add inclusion, If the add for inclusion is successful, LED will turn on within 2 seconds and Then will be in power indication mode, Otherwise, The LED will keep slow flash.
1. Set the Z-Wave network main controller into removing mode.
2. Short press Z-button twice.
3. The LED keep blink to the end of remove exclusion, If the remove for exclusion is successful, The LED will keep slow flash, Otherwise, LED will be in power indication mode.
Factory reset EU Smart Plug
Reset Smart Plug to factory Default:
1. Make sure that the Smart Plug has been connected to the power supply.
2. Press and hold the Z-button for 5 seconds.
3. If holding time is more than one second, the LED will blink faster and faster. If holding time is more than 5 seconds, the LED will be solid for 3 seconds to indicate that the resetting is successful. Otherwise, repeat step 2.
Use this procedure only in the event that the network primary controller missing or otherwise inoperable.
Please note that this is a user manual EU Smart Plug from LEEDARSON is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have EU Smart Plug and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.