The following is an overview of the user manual for the Z-Wave product Motion Sensor Pet Immunity Z-Wave 700 (7CA-SS-VE-C0)from LEEDARSON. To view other Z-Wave products and manuals from Leedarson follow that link.
Overview
Security
As a Z-Wave Plus certified product, Motion Sensor Pet Immunity Z-Wave 700 supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Leedarson describes Motion Sensor Pet Immunity Z-Wave 700 as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
SmartStart location
SmartStart QR code's location as follows: on the saide of the product
Remove Motion Sensor from a Z-Wave network:
1. Power on your Motion Sensor, and let the Z-Wave primary controller into remove mode.
2. Press the button on the Motion Sensor, the LED will be turn on for 60seconds.
3. If Motion Sensor has been successfully removed from your Z-Wave network, the LED will be fast blink 2 seconds. If failed, LED will be turn off forever, and please repeat the steps in above.
In the network: Send Wake up notification, and LED will fast blink when sending data, send over then the LED turn off.
Factory reset Motion Sensor Pet Immunity Z-Wave 700
Reset Motion Sensor to factory default.
NOTE:
1. Triggering this action, in 5 seconds LED will be fast blink. The LED will be turn on within 2 second until hold time is equal to 5 seconds. Motion Sensor will send “Device_Reset_Locally” to the main controller and exclude from the Z-Wave network when the button is released, this procedure will reset the sensor to factory default.
2. Please use this procedure only when the network primary controller is missing or otherwise inoperable.
3. When not in the network, ignore this operation.
NA
NA
Add the Motion Sensor into the Z-Wave network:
1. Power on your Motion Sensor, and let your Z-Wave controller into add/inclusion mode.
2. Implement the button action, the Motion Sensor will send out a node info security CC in command class list (Security inclusion), the LED will be fast blink for 60 seconds.
3. If the inclusion is successful, the LED will be turn on within 2 seconds. If failed, LED will be turn off forever, and please repeat the steps in above.
Please note that this is a user manual Motion Sensor Pet Immunity Z-Wave 700 from LEEDARSON is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Motion Sensor Pet Immunity Z-Wave 700 and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.