The following is an overview of the user manual for the Z-Wave product Multi-Sensor (7A-SS-AABC-H0)from LEEDARSON. To view other Z-Wave products and manuals from Leedarson follow that link.
Overview
Security
As a Z-Wave Plus certified product, Multi-Sensor supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
Leedarson describes Multi-Sensor as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- Sensors
- Battery Quantity
- Battery powered using CR123A batteries
- Supported Notification Types
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Add Multi-Sensor into a Z-Wave network:
a. Let the primary controller go into inclusion mode (If you don’t know how to do this, refer to its manual).
b. Short Press one time this Z-Button.
c. The Multi-Sensor LED will blink, If the inclusion is successful, then LED will keep on 2 seconds. Otherwise, the LED will blink until timeout, in which case you need to repeat the process from step b.
Remove Multi-Sensor from a Z-Wave network:
a. Let the primary controller go into exclusion mode (If you don’t know how to do this, refer to its manual).
b. Short Press one time this Z-Button.
c. The Multi-Sensor LED will keep on, If the remove is successful, then LED will blink 2 seconds. Otherwise, the LED will keep on until timeout, in which case you need to repeat the process from step b.
Note: Multi-Sensor will go away“SmartStart”Inclusion when it is removed from a Z-Wave network.
Factory reset Multi-Sensor
Reset Multi-Sensor to factory Default:
1. Press and hold the Z-Button for 5seconds.
2. If holding time is more than 5seconds, the LED will blink fast at acceleration. If reset success Multi-Sensor LED will turn off. When the Z-Button is released, it will send “Device Reset Locally Command”. Otherwise please repeat step 2.
Note:
1, This procedure should only be used when the primary controller is inoperable.
2, Reset Multi-Sensor to factory default settings. It will set the Multi-Sensor to not in Z-Wave network state; delete the Association setting and restore the Configuration setting to the default.
Please note that this is a user manual Multi-Sensor from LEEDARSON is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Multi-Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.