The following is an overview of the user manual for the Z-Wave product NA Smart Plug(Z-Wave) (6A-PL-VAB-A0)from LEEDARSON. To view other Z-Wave products and manuals from Leedarson follow that link.
Overview
Smart Plug is also a security Z-Wave device and supports the Over The Air (OTA) feature for the product’s firmware upgrade.
Security
As a Z-Wave Plus certified product, NA Smart Plug(Z-Wave) supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
Leedarson describes NA Smart Plug(Z-Wave) as having the following features:
- Supported Meter Type
- Switch Type
- Z-Wave Scene Type
- Firmware updatable via a compatible Z-Wave gateway
- Switch Load Capacity Watts
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
To add the product to the Z-Wave network:
a. Make sure that the Smart Plug has been connected to the power supply.
b. Set the Z-Wave network main controller into inclusion mode.
c. Power on.
d. The LED will blink fast until the inclusion is completed and then the LED will keep turning on or off. Otherwise, the LED will still blink slowly, in which you need to repeat the process from step b
To remove the product from the Z-Wave network:
a. Insert the Smart Plug to power socket, the LED will follow the status (on or off) of its load’s power level.
b. Set the Z-Wave network main controller into exclusion mode.
c. Short press Button 3 times within 1.5 second.
d. The LED will blink fast until the exclusion is completed, then the LED will keep on blinking slowly. Otherwise, the LED will keep on blink fast for 35 seconds and then follow the status (on or off) of its load status.
Factory reset NA Smart Plug(Z-Wave)
Reset Smart Plug to factory default:
1. Make sure that the Smart Plug has been connected to the power supply.
2. Press and hold the Button for 5 seconds.
3. If holding time is more than one second, the LED will blink faster and faster. If holding time is more than 5 seconds, the LED will be solid for 3 seconds to indicate that the resetting is successful. Otherwise, repeat step 2.
Note:
Reset to factory will remove Smart Plug from the Z-Wave network. Use this procedure only in the event that the network primary controller missing or otherwise inoperable.
Please note that this is a user manual NA Smart Plug(Z-Wave) from LEEDARSON is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have NA Smart Plug(Z-Wave) and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.